![]() ![]() To get this option if you are only seeing the short menu, there should be a "show all blocks" drop-down arrow at the bottom of your block menu. You can set this to operate one motor or multiple motors. In the extended word-block menu is a block for "go shortest path to position 0". If you think this might be the case, it's probably more likely something you misunderstood in the program (that was my problem) or a building error.įor troubleshooting, it is nice to be able to check the motors are zeroed properly, and I found a quicker way to check it without unbuilding anything (*). Since you put an axle in when you lock the motor for calibrating, there are only 4 possible orientations that is, it is very unlikely to be miscalibrated by a few degrees. As a followup, I realized my motor was not miscalibrated and it's actually pretty unlikely to calibrate it wrong. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |